Bearing Induction Heater Copper Heating Coil Heater

This series of products is equipped with a mobile cart, the overall height of the fuselage is increased, and the design is more user-friendly, which is convenient for operators to move loading and unloading work.Fy Bearing Heater
1. Safe, clean and environmentally friendly Traditional methods, such as live roasting, oil bath and oven roasting, are not only expensive but also produce coke smoke, odor and waste oil. Fag Bearing Heater The application of induction heaters can be an alternative to traditional methods to create a safe and clean working environment. 2. Fast and no damage After heating, the bearing expands outward in a cylindrical direction, which can avoid damage during installation. Induction heating is a good heating method, and it does not require preheating. Depending on the weight, the bearing can be heated to 120°C in seconds or minutes without damaging the pre-lubrication. 3. Rationalized design In order to meet the requirements of the industrial environment, the design concept of ELD heating is modernization, rationalization, easy operation and high durability. Among them, the ELDC-1 type is a convenient type for on-site use. Operation procedure: 1: Turn on the power as required, at this time the host automatically detects the probe and ambient temperature, and displays the ambient temperature at the same time. 2: Press the function button to select temperature or time control, if you need to adjust the temperature or time, please press the up or down button to select the appropriate parameter (when temperature control is selected, the magnetic probe is attached to the outer side of the inner ring of the bearing. , Bearing high heating temperature should not exceed 120 ℃ 3: Press the start button, the host starts to heat the workpiece, when the time is set, the host automatically stops heating and automatically demagnetizes the workpiece. During temperature control, when the set temperature is reached, the workpiece is in Constant temperature state, when you need to press the stop button to install. 4: Remove the workpiece to install. 5: To heat the same workpiece, please use the time control, please automatically remember the time required for the last heating. Notes: 1: This 2: It is strictly forbidden to start the main engine without a heating shaft; 3: When heating the workpiece, try to choose a larger heating shaft to improve work efficiency; 4: The high temperature of the bearing should not exceed 120℃; 5: Take away the workpiece and pay attention to high temperature to prevent burns; 6: Please do not place the probe on the workpiece for a long time to prolong the service life of the probe.Cone Bearing Heater